Application module: Kinematic analysis control and result ISO/TS 10303-1817:2014-02(E)
© ISO

Cover page
Table of contents
Copyright
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and abbreviated terms
    3.1 Terms and definitions
    3.2 Abbreviated terms

4 Information requirements
   4.1 Required AM ARM
   4.2 ARM type definitions
   4.3 ARM entity definitions
   4.4 ARM subtype constraint definition
5 Module interpreted model
   5.1 Mapping specification
   5.2 MIM EXPRESS short listing

A MIM short names
B Information object registration
C ARM EXPRESS-G   EXPRESS-G
D MIM EXPRESS-G   EXPRESS-G
E Computer interpretable listings
Bibliography
Index

Annex E
(informative)

Computer interpretable listings

This annex references a listing of the EXPRESS entity names and corresponding short names as specified or referenced in this part of ISO 10303. It also provides a listing of each EXPRESS schema specified in this part of ISO 10303 without comments nor other explanatory text. These listings are available in computer-interpretable form in Table E.1 and can be found at the following URLs:

   Short names: http://standards.iso.org/iso/10303/tech/short_names/short_names.txt
   EXPRESS: http://standards.iso.org/iso/10303/smrl/v5/tech/smrlv5.zip

Table E.1 — ARM and MIM EXPRESS listings

Description HTML file ASCII file Identifier
ARM short form EXPRESS HTML EXPRESS ISO TC184/SC4/WG12 N7900
MIM short form EXPRESS HTML EXPRESS ISO TC184/SC4/WG12 N7901

If there is difficulty accessing these sites, contact ISO Central Secretariat.

NOTE  The information provided in computer-interpretable form at the above URLs is informative. The information that is contained in the body of this part of ISO 10303 is normative.



© ISO 2014 — All rights reserved